The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
  • The chart below shows dimensions for locknuts and lockwashers used in the mounting of straight bore bearings on shafts.
  • Other dimensions and tolerances related to shaft configurations are also shown.
  • Dimensions are presented according to bearing bore size and are applicable to bearings in the various series (e.g., 222 and 223 etc.).
Unit of Measure

Specifications

Bearing Bore

 N/A 95 mm

Locknut

 N/A AN 19

Lockwasher

 N/A W 19

Threads

Major Diameter

 N/A 94.74 mm3.73 in

Threads No. per Inch

 N/A 12

Shaft

Relief Diameter A

 N/A 91.62 mm3.607 in

Diameter S-3

 N/A 90.49 mm3.5625 in
W1 N/A 4.37 mm0.172 in
L2 N/A 17.45 mm0.687 in
H3 N/A 4 mm0.156 in
S4 N/A 9.53 mm0.375 in
M5 N/A 6.35 mm0.25 in

Locknut

C1

 N/A 125.55 mm4.943 in

D

 N/A 18.52 mm0.729 in

Lockwasher

Q

 N/A 2.13 mm0.084 in

R

 N/A 96.52 mm3.8 in

B

 N/A 132.56 mm5.219 in

s

 N/A 8.97 mm0.353 in
  • 1 Tolerance -0 to + 0.4 mm (-0 to +1/64 in)
  • 2 Tolerance -0 to + 0.4 mm (-0 to +1/64 in)
  • 3 Tolerance -0 to + 0.4 mm (-0 to +1/64 in)
  • 4 Tolerance -0 to + 0.4 mm (-0 to +1/64 in)
  • 5 Tolerance -0 to + 0.4 mm (-0 to +1/64 in)