The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
Key Features
    • Longer bearing life achieved from higher capacity (vs. competitors)
    • Longer lubrication life achieved from lower operating temperatures due to reduced internal friction and running torque from cage guided rollers
    • Improved bearing performance in extreme operating conditions, minimizing impact of contaminants that can get caught in the bearing's roller and cage due to an enhanced cage bridge design
    • Extend bearing life in applications with extreme shock/vibration, high gravitational forces and minimal lubrication conditions due to the extra strength and durability provided by our machined brass cage
Unit of Measure

Key Dimensions

Bore (d)

 N/A 200 mm

O.D. (D)

 N/A 420 mm16.535 in

Width (B)

 N/A 165 mm6.4960 in

Dynamic Radial Load Rating - 1M Revs (C1)

 N/A 2940000 N660000 lbf
e Factor1 N/A 0.41

Other Dimensions

Max Shaft Fillet Radius2 N/A 4 mm0.160 in

Shaft Backing Shoulder Diameter

 N/A 246.000 mm9.700 in

Housing Backing Shoulder Diameter

 N/A 366.000 mm14.4000 in

Design Unit

 N/A Metric

Ratings

Static Radial Load Rating (C0)

 N/A 3730000 N838000 lbf

Thermal Reference Speed - Grease 

 N/A 680 rpm
Thermal Reference Speed - Oil3 N/A 730 rpm

Factors

Y0 Factor4 N/A 1.62
Y1 Factor 5 N/A 1.66
Y2 Factor 6 N/A 2.47
Geometry Factor (Cg)7 N/A 0.1043
  • 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 2 Maximum housing fillet radius that bearing corners will clear.
  • 3 See thermal speed ratings in the engineering section.
  • 4 These factors apply for both inch and metric calculations. See engineering
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.