The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
Spherical bearings are designed to manage high radial loads even when misalignment, poor lubrication, contamination, extreme speeds or critical application stresses are present.
Unit of Measure

Specifications

UPC Code

 N/A 087796359673

Design Unit

 N/A Metric

d - Bore

 N/A 220 mm

Lubrication Type

 N/A Standard Grease

Cage Type

 N/A EJ

Cage Material

 N/A Steel

Superseded Part

 N/A 22244CJW29W33C3

Factors

e - ISO Factor1 N/A 0.27
Y0 - ISO Factor2 N/A 2.45
Y1 - ISO Factor3 N/A 2.51
Y2 - ISO Factor4 N/A 3.73

Reference Thermal Speed Rating (Grease)

 N/A 1300 rpm
Reference Thermal Speed Rating (Oil)5 N/A 1500 rpm
Cg - Geometry Factor6 N/A 0.1057

Dimensions

D - Outer Diameter

 N/A 400 mm15.748 in

B' - Inner Ring Width

 N/A 108 mm4.252 in

B - Outer Ring Width

 N/A 108 mm4.2520 in

Abutment and Fillet Dimensions

R - Inner Ring "To Clear" Radius7 N/A 3 mm0.120 in
r - Outer Ring "To Clear" Radius8 N/A 3 mm0.12 in

da - Inner Ring Backing Diameter

 N/A 261 mm10.3000 in

Da - Outer Ring Backing Diameter

 N/A 359.000 mm14.100 in

Basic Load Ratings

C0 - Static Radial Rating

 N/A 2310000 N520000 lbf

C1(2) - Dynamic Radial Rating (Two-Rows)

 N/A 1850000 N415000 lbf
  • 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 2 These factors apply for both inch and metric calculations. See engineering
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 See thermal speed ratings in the engineering section.
  • 6 Geometry constant for Lubrication Life Adjustment Factor a3l.
  • 7 Maximum housing fillet radius that bearing corners will clear.
  • 8 These maximum fillet radii will be cleared by the bearing corners.