The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
Spherical bearings are designed to manage high radial loads even when misalignment, poor lubrication, contamination, extreme speeds or critical application stresses are present.
Unit of Measure

Specifications

UPC Code

 N/A 087796312944

Design Unit

 N/A Metric

d - Bore

 N/A 200 mm

Lubrication Type

 N/A Standard Grease

Cage Type

 N/A EJ

Cage Material

 N/A Steel

Superseded Part

 N/A 23140CJW33

Factors

e - ISO Factor1 N/A 0.31
Y0 - ISO Factor2 N/A 2.1
Y1 - ISO Factor3 N/A 2.15
Y2 - ISO Factor4 N/A 3.2

Reference Thermal Speed Rating (Grease)

 N/A 1200 rpm
Reference Thermal Speed Rating (Oil)5 N/A 1400 rpm
Cg - Geometry Factor6 N/A 0.0978

Dimensions

D - Outer Diameter

 N/A 340 mm13.3858 in

B' - Inner Ring Width

 N/A 112 mm4.4094 in

B - Outer Ring Width

 N/A 112 mm4.4094 in

Abutment and Fillet Dimensions

R - Inner Ring "To Clear" Radius7 N/A 2.5 mm0.100 in
r - Outer Ring "To Clear" Radius8 N/A 2.5 mm0.1 in

da - Inner Ring Backing Diameter

 N/A 230 mm9.0000 in

Da - Outer Ring Backing Diameter

 N/A 308 mm12.1000 in

Basic Load Ratings

C0 - Static Radial Rating

 N/A 2290000 N514000 lbf

C1(2) - Dynamic Radial Rating (Two-Rows)

 N/A 1660000 N373000 lbf
  • 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 2 These factors apply for both inch and metric calculations. See engineering
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 See thermal speed ratings in the engineering section.
  • 6 Geometry constant for Lubrication Life Adjustment Factor a3l.
  • 7 Maximum housing fillet radius that bearing corners will clear.
  • 8 These maximum fillet radii will be cleared by the bearing corners.