COMPANY HEADER
Print Back
Tapered Roller Bearings - 2TS-IM (Matched Bearing Assembly, Indirect Mount)
Unit of Measure

Specifications

Cone Part Number

 N/A 898

Cup Part Number

 N/A 892

Inner Spacer Part Number

 N/A X4S-898

Outer Spacer Part Number

 N/A Y5S-892

Design Unit

 N/A Inch

Dimensions

d - Bore

 N/A 5 1/2 in

D - Cup Outer Diameter

 N/A 9 in

T - Width

 N/A 4.8750 in

C - Width

 N/A 3.875 in

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 N/A 0.14 in
r - Cup Backface "To Clear" Radius2 N/A 0.06 in

db - Cone Backface Backing Diameter

 N/A 6.38 in

Da - Cup Frontface Backing Diameter

 N/A 8.54 in

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)3 N/A 30300 lbf135000 N
C1 - Dynamic Radial Rating (1 million revolutions)4 N/A 204000 lbf906000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)5 N/A 21800 lbf97200 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)6 N/A 52800 lbf235000 N

Factors

K - Factor7 N/A 1.39
e - ISO Factor8 N/A 0.42
Y1 - ISO Factor9 N/A 1.6
Y2 - ISO Factor10 N/A 2.39
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 4 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.