COMPANY HEADER
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A LM286249

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 2550000 lbf11400000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 662000 lbf2940000 N

Dimensions

d - Cone Bore

 N/A 34.0000 in

B - Cone Width

 N/A 7.3125 in

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.380 in

da - Cone Frontface Backing Diameter

 N/A 35.67 in

db - Cone Backface Backing Diameter

 N/A 36.02 in

Ab - Cage-Cone Frontface Clearance

 N/A 0.03 in

Aa - Cage-Cone Backface Clearance

 N/A 0.48 in
a - Effective Center Location4 N/A 0.56 in

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 380000 lbf1690000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 1470000 lbf6520000 N

C0 - Static Radial Rating

 N/A 3920000 lbf17400000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 216000 lbf963000 N

Factors

K - Factor8 N/A 1.76

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 28956.1

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 1086.1
Cg - Geometry Factor9 N/A 0.393
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.