The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 127000

Cup Part Number

 N/A 127137

Design Units

 N/A Imperial

Dimensions

D - Cup Outer Diameter

 N/A 13.8125 in350.838 mm

C - Cup Width

 N/A 1.75 in44.45 mm

Abutment and Fillet Dimensions

r - Cup Backface "To Clear" Radius1 N/A 0.130 in3.30 mm

Da - Cup Frontface Backing Diameter

 N/A 12.99 in329.90 mm

Db - Cup Backface Backing Diameter

 N/A 12.80 in325.12 mm

Factors

K - Factor2 N/A 1.65
e - ISO Factor3 N/A 0.35
Y - ISO Factor4 N/A 1.7

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 1178.6

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 164.4
Cg - Geometry Factor5 N/A 0.139
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 Geometry constant for Lubrication Life Adjustment Factor a3l.