COMPANY HEADER
Print Back
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
Unit of Measure

Specifications

Series

 N/A 15000

Cup Part Number

 N/A 15250-B

Design Units

 N/A Imperial

Dimensions

D - Cup Outer Diameter

 N/A 2.5000 in

D1 - Flange Outer Diameter

 N/A 2.6522 in

C - Cup Width

 N/A 0.625 in

C1 - Cup Flange Width

 N/A 0.1562 in

Abutment and Fillet Dimensions

r - Cup Backface "To Clear" Radius1 N/A 0.050 in

Da - Cup Frontface Backing Diameter

 N/A 2.40 in

Factors

K - Factor2 N/A 1.67
e - ISO Factor3 N/A 0.35
Y - ISO Factor4 N/A 1.71
Cg - Geometry Factor5 N/A 0.0606
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 Geometry constant for Lubrication Life Adjustment Factor a3l.