COMPANY HEADER
Print Back
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
Unit of Measure

Specifications

Series

 N/A HM813800

Cup Part Number

 N/A HM813815-B

Design Units

 N/A Imperial

Dimensions

D - Cup Outer Diameter

 N/A 5.1260 in

D1 - Flange Outer Diameter

 N/A 5.4410 in

C - Cup Width

 N/A 1.0625 in

C1 - Cup Flange Width

 N/A 0.4071 in

Abutment and Fillet Dimensions

r - Cup Backface "To Clear" Radius1 N/A 0.130 in

Da - Cup Frontface Backing Diameter

 N/A 4.89 in

Factors

K - Factor2 N/A 1.16
e - ISO Factor3 N/A 0.5
Y - ISO Factor4 N/A 1.2

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 1990

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 260
Cg - Geometry Factor5 N/A 0.125
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 Geometry constant for Lubrication Life Adjustment Factor a3l.