The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
When faced with flat horizontal or vertical faces, flange units offer a simple mounting solution. As with pillow block supports, flange units are produced with spherical location to accommodate standard bearing housings and provide easy initial alignment of shaft and equipment.

To facilitate positive location of the flange to the surface, the rear face is recessed (dimensions N & V). This allows for a spigot (Tolerance f8) to be located into the flange.

Bearing inspection is simply a matter of removing the top half of the flange and housing. Bearing replacement may also be achieved in the same manner if required.

When integrating flange units into new applications, it should be noted that a maximum radial load equivalent to 0.26Cor is permissible. A maximum axial load of 0.25Ca must also be taken into account for applications with thrust loading. Units for vertically oriented shafts may also need special consideration given to sealing arrangements.

As always, Timken will be happy to advise on any application issues.
Unit of Measure

Specifications

Series Type

 N/A Light Series

Shaft Size

 N/A 8 in

Seal Type

 N/A Aluminium Triple Labyrinth

Bearing Type

 N/A Marine Split Cylindrical Expansion Type

Type

 N/A Round Flange

Bearing Number

 N/A LSE800BX

Housing

 N/A LSE800BXHATL

Dimensions

Outside Diameter

 N/A 21.0 in534 mm

Bearings Ratings

Cr - Dynamic Load Rating

 N/A 138033 lbf614000 N

Cor - Static Load Rating

 N/A 222561 lbf990000 N

Maximum Speed

 N/A 1070 rpm

Note

Note

 N/A Timken offers a wide range of sealing options including: KPS, RSS, ATL and HTPS seals.

Please review for more options.