All Product Types > INDUSTRIAL MOTION PRODUCTS > Couplings & Power Transmission Parts Catalog > Variable Speed Drives > Aluminoline Series Variable Speed Drives > Model 145 Spring-Loaded Driver Pulleys - Imperial > Part Number 68514418525  

Part Number 68514418525, Model 145 Spring-Loaded Driver Pulleys - Imperial

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

Two-Side Moveable
1/3 through 1-1/2 HP
“A” and “B” Belts
      Aluminoline variable speed pulleys are designed for the best possible belt alignment with the least amount of overhung load. Flanges are made of a lightweight, corrosion-resistant aluminum, which is hard-coat anodized for long life. The aluminum flanges provide quiet operation with minimum vibration. These pulleys are used with classical “A” and “B” drive belts. Aluminoline pulleys offer maximum service when lubricated through a convenient grease fitting located on the end of the pulley shaft.

    Belt Selection
      Aluminoline variable speed pulleys are designed to drive standard “A” and “B” section belts. Due to the intermeshing flange design, it is best to use a wrapped belt or one without cogs.

    Adjustable Center Drives
      The typical adjustable center drive consists of the Aluminoline pulley mounted on the motor shaft, a companion sheave on the driven shaft, an adjustable motor base and a belt. Standard “A” and “B” fixed diameter sheaves should be used as driven companion sheaves. Belt alignment will be maintained throughout the speed range because the Aluminoline pulleys are two-side moveable. Due to the minimal bottom contact area of “A” and “B” belts, flat driven sheaves are NOT recommended.





Specifications  · Dimensional Data  · Performance Data  · Features

Specifications

Description 
145-5/8-PULLEY

Drive Type
Adjustable Center - Driver

Belt Size
A

Ratio
2:1

Weight
2.12 lb

UPC Number
18525


Dimensional Data

Bore Diameter 
5/8 in

Keyway Size 
3/16 x 3/32 in

Width
1.380 in
35.05 mm

Outside Diameter
4.50 in

Max. Pitch Diameter (Dimension PD)
4.250 in

Min. Pitch Diameter (Dimension PD)
2.100 in

Overall Length
4.810 in
122.17 mm

Cubic inches
97.40250 in³


Performance Data

Torque Capacity
18.00 in·lb

Motor Power at 1,150 rpm
0.30 hp

Motor Power at 1,750 rpm
0.50 hp


Features

Features 
  • Ratings for 1/3 through 1-1/2 HP motors
  • Unique “intermeshing” flange design
  • Greater speed ratios (up to 2.75 to 1) with a narrow-belt adjustable center drive than any other pulley


 MORE IMAGES 

·  Motor Base - Model 145 Spring-Loaded Driver Pulleys

·  Belt - Model 145 Spring-Loaded Driver Pulleys

·  HP vs Speed - Model 145 Spring-Loaded Driver Pulleys