3D CAD and 2D Drawings

Find and download 3D CAD and 2D drawings for key Timken products.

Batch CAD Cart (0)
  • Cart is empty
FSPCR Type (F Type with a Spacer)

This drop-out spacer design allows for ease of maintenance without disturbing the equipment mountings. It has a lightweight construction to reduce the load on equipment bearings.

The FSPCR Type coupling consists of two standard F Type flex hubs, two standard F Type sleeves, one FSPCR Type spacer and two accessory kits. This coupling is available in either exposed bolts or shrouded bolt design.

Note: BSE = Distance "Between Shaft Ends"

Unit of Measure




Hub Style

N/A Shrouded Bolt


N/A Spacer

Hub Material

N/A AISI 1045


N/A Gear Spacer


N/A Metallic

Coupling Type

N/A Gear


N/A 22.60 lb

Complete Coupling Weight (Less Spacer)

N/A 80.00 lb

Dimensional Data


N/A 3

Length thru Bore

N/A 3.590 in91.19 mm

Overall Length 

N/A 7" Between Shaft End Measurement

Max. Bore (Dimensions ID1/ID2)

N/A 4.213 in107 mm

Dimension AD

N/A 3.970 in100.84 mm

Dimension D1

N/A 6.500 in165.10 mm

Dimension D2

N/A 5.750 in146.05 mm

Dimension FD

N/A 5.630 in143.00 mm

Dimension G

N/A 0.09 in2.29 mm

Dimension S

N/A Determined by Shaft Separation

Distance between Shaft Ends (Dimension BSE)

N/A 7.000 in177.80 mm

Cubic inches

N/A 221.87830 in³

Performance Data

Nominal Torque

N/A 94500 in·lb

Max. Speed (Unbalanced)

N/A 4000 rpm

Max. Speed (Balanced)

N/A 6000.00 rpm

Max. Angular Misalignment

N/A 1.50º per Gear Mesh



  • Patented Vari-Crown® tooth form for long life
  • Standard 20° pressure angle
  • Heat treated bolts for greater strength
  • Corrosion resistant bolts and nuts for ease of maintenance
  • Provides parallel, angular misalignment and end float
  • Removal of spacer provides adequate space for the removal of either coupling half without moving the driver or driven units



  • Max. Speed indicates maximum RPM of spacer set determined by critical speed of spacer.
  • Exposed Bolt Design is standard.
  • Shrouded Bolt Design available upon request for sizes 1 through 5.5.
  • Puller Holes are standard on sizes 4 through 9.
  • Puller Holes are available for sizes 1 through 3.5 at an additional charge.
  • Interference bores with no set screws are standard unless otherwise specified.
  • Inch bore and keyway tolerances conform to AGMA 9002-B04.
  • For metric bore and keyway tolerances, consult Lovejoy Engineering Section.
By clicking Submit, you consent to the personal information you provide being accessible by Timken personnel, who may be located outside your home country, as described in our Privacy Notice.