All Product Types > ENGINEERED BEARINGS > Tapered Roller Bearings > Tapered Roller Bearings - Double Cones > Tapered Roller Bearings - Double Tapered Cones - Imperial > Part Number 07100D  

Part Number 07100D, Tapered Roller Bearings - Double Tapered Cones - Imperial

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.




Specifications  · Dimensions  · Abutment and Fillet Dimensions  · Basic Load Ratings  · Factors

Specifications

Series
07000

Cone Part Number
07100D

Design Units
Imperial

Cage Type
Stamped Steel

C1 - Dynamic Radial Rating (1 million revolutions)1
6540 lbf
29100 N

C0 - Static Radial Rating
6650 lbf
29600 N
1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.


Dimensions

d - Cone Bore
1 in
25.40 mm

B - Double Cone Width
1.4375 in
36.513 mm


Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1
0.03 in
0.800 mm

da - Cone Frontface Backing Diameter
1.18 in
30 mm

Ab - Cage-Cone Frontface Clearance
-0.07 in
-1.8 mm
1 These maximum fillet radii will be cleared by the bearing corners.


Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)1
1700 lbf
7550 N

C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)2
11400 lbf
50700 N

C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)3
2950 lbf
13100 N

Ca90 - Dynamic Thrust Rating (90 million revolutions)4
1170 lbf
5190 N
1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.


Factors

K - Factor1
1.45

Cg - Geometry Factor2
0.0509
1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
2 Geometry constant for Lubrication Life Adjustment Factor a3l.



 DOWNLOADS 

Bearing Life Calculation Tool

Bearing Dimensional Tolerances