All Product Types > ENGINEERED BEARINGS > Tapered Roller Bearings > Tapered Roller Bearings - Double Cones > Tapered Roller Bearings - Double Tapered Cones - Imperial > Part Number 13176D  

Part Number 13176D, Tapered Roller Bearings - Double Tapered Cones - Imperial

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.




Specifications  · Dimensions  · Abutment and Fillet Dimensions  · Basic Load Ratings  · Factors

Specifications

Series
13000

Cone Part Number
13176D

Design Units
Imperial

Cage Type
Stamped Steel

C1 - Dynamic Radial Rating (1 million revolutions)1
11400 lbf
50800 N

C0 - Static Radial Rating
13700 lbf
61100 N
1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.


Dimensions

d - Cone Bore
1 3/4 in
44.45 mm

B - Double Cone Width
1.2500 in
31.750 mm


Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1
0.005 in
0.13 mm

da - Cone Frontface Backing Diameter
1.97 in
50 mm

Ab - Cage-Cone Frontface Clearance
0.11 in
2.8 mm
1 These maximum fillet radii will be cleared by the bearing corners.


Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)1
2960 lbf
13200 N

C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)2
19900 lbf
88500 N

C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)3
5160 lbf
22900 N

Ca90 - Dynamic Thrust Rating (90 million revolutions)4
2680 lbf
11900 N
1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.


Factors

K - Factor1
1.11

Cg - Geometry Factor2
0.0799
1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
2 Geometry constant for Lubrication Life Adjustment Factor a3l.



 DOWNLOADS 

Bearing Life Calculation Tool

Bearing Dimensional Tolerances