All Product Types > ENGINEERED BEARINGS > Tapered Roller Bearings > Tapered Roller Bearings - Double Cones > Tapered Roller Bearings - Double Tapered Cones - Imperial > Part Number 94704D  

Part Number 94704D, Tapered Roller Bearings - Double Tapered Cones - Imperial

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.




Specifications  · Dimensions  · Abutment and Fillet Dimensions  · Basic Load Ratings  · Factors

Specifications

Series
94000

Cone Part Number
94704D

Design Units
Imperial

Cage Type
Stamped Steel

C1 - Dynamic Radial Rating (1 million revolutions)1
148000 lbf
660000 N

C0 - Static Radial Rating
242000 lbf
1070000 N
1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.


Dimensions

d - Cone Bore
7 in
177.800 mm

B - Double Cone Width
6.2500 in
158.750 mm


Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1
0.06 in
1.5 mm

da - Cone Frontface Backing Diameter
7.68 in
195 mm

Ab - Cage-Cone Frontface Clearance
0.25 in
6.3 mm
1 These maximum fillet radii will be cleared by the bearing corners.


Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)1
38500 lbf
171000 N

C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)2
258000 lbf
1150000 N

C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)3
67000 lbf
298000 N

Ca90 - Dynamic Thrust Rating (90 million revolutions)4
30800 lbf
137000 N
1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.


Factors

K - Factor1
1.25

Cg - Geometry Factor2
0.129
1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
2 Geometry constant for Lubrication Life Adjustment Factor a3l.



 DOWNLOADS 

Bearing Life Calculation Tool

Bearing Dimensional Tolerances