All Product Types > ENGINEERED BEARINGS > Tapered Roller Bearings > Tapered Roller Bearings - Double Cones > Tapered Roller Bearings - Double Tapered Cones - Imperial > Part Number HM959744DW  

Part Number HM959744DW, Tapered Roller Bearings - Double Tapered Cones - Imperial

    Download PDF Download PDF   
    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites
  

TDI bearings have a one-piece double inner race and two single outer races and are typically supplied complete with an outer race spacer as a pre-set assembly. The bearing can be used at fixed positions on rotation shaft applications. For rotating housing application it can be used to float on the stationary shaft.




Specifications  · Dimensions  · Abutment and Fillet Dimensions  · Basic Load Ratings  · Factors

Specifications

Series
HM959700

Cone Part Number
HM959744DW

Design Units
Imperial

Cage Type
Pin-Type

C1 - Dynamic Radial Rating (1 million revolutions)1
321000 lbf
1430000 N

C0 - Static Radial Rating
612000 lbf
2720000 N
1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.


Dimensions

d - Cone Bore
12.0140 in
305.156 mm

B - Double Cone Width
7.8750 in
200.025 mm


Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1
0.13 in
3.300 mm

da - Cone Frontface Backing Diameter
13.62 in
345.9 mm

Ab - Cage-Cone Frontface Clearance
0.12 in
3.05 mm
1 These maximum fillet radii will be cleared by the bearing corners.


Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)1
83100 lbf
370000 N

C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)2
558000 lbf
2480000 N

C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)3
145000 lbf
644000 N

Ca90 - Dynamic Thrust Rating (90 million revolutions)4
123000 lbf
548000 N
1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.


Factors

K - Factor1
0.67

Cg - Geometry Factor2
0.225
1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
2 Geometry constant for Lubrication Life Adjustment Factor a3l.



 DOWNLOADS 

Bearing Life Calculation Tool

Bearing Dimensional Tolerances