COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 230000

Cone Part Number

 N/A EE231400

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 412000 lbf1830000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 107000 lbf475000 N

Dimensions

d - Cone Bore

 N/A 14 in355.6 mm

B - Cone Width

 N/A 2.6250 in66.675 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.4 mm

da - Cone Frontface Backing Diameter

 N/A 14.92 in379 mm

db - Cone Backface Backing Diameter

 N/A 15.28 in388.0 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.3 in7.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.71 in18 mm
a - Effective Center Location4 N/A 0.77 in19.6 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 61300 lbf273000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 236000 lbf1050000 N

C0 - Static Radial Rating

 N/A 420000 lbf1870000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 46200 lbf206000 N

Factors

K - Factor8 N/A 1.33

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 2386

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 366.8
Cg - Geometry Factor9 N/A 0.187
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.