COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 333000

Cone Part Number

 N/A EE333140

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 529000 lbf2350000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 137000 lbf610000 N

Dimensions

d - Cone Bore

 N/A 14 in355.6 mm

B - Cone Width

 N/A 3.3125 in84.138 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.4 mm

da - Cone Frontface Backing Diameter

 N/A 14.84 in377 mm

db - Cone Backface Backing Diameter

 N/A 15.24 in387 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.18 in4.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.43 in10.9 mm
a - Effective Center Location4 N/A 0.14 in3.6 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 78700 lbf350000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 304000 lbf1350000 N

C0 - Static Radial Rating

 N/A 626000 lbf2780000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 49500 lbf220000 N

Factors

K - Factor8 N/A 1.59

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 3040

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 337
Cg - Geometry Factor9 N/A 0.193
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.