COMPANY HEADER
CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A LL575343

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 349000 lbf1550000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 90500 lbf403000 N

Dimensions

d - Cone Bore

 N/A 21.0000 in533.400 mm

B - Cone Width

 N/A 2 in50.8 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.35 mm

da - Cone Frontface Backing Diameter

 N/A 21.61 in549 mm

db - Cone Backface Backing Diameter

 N/A 21.97 in558 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.19 in4.8 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.12 in3 mm
a - Effective Center Location4 N/A 2 in50.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 52000 lbf231000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 201000 lbf892000 N

C0 - Static Radial Rating

 N/A 459000 lbf2040000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 36100 lbf161000 N

Factors

K - Factor8 N/A 1.44

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 4810

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 1200
Cg - Geometry Factor9 N/A 0.227
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.