Request Information
RRU Type - Drop-Out Style
    The RRU Type Uniflex coupling is designed for fast, easy installation and removal without disrupting the connected shafts. This is ideal when servicing impellers, bearings and seals. The design consists of two steel hubs fastened with cap screws to a Uniflex double flange coupling (UF Type). The RRU is easily disassembled by simply removing the cap screws and sliding out the UF center spring section.
    This design offers “quick disconnect” for drop out requirements. It can also accommodate a slightly larger shaft diameter than the standard U Type.
    Note: A complete RRU Type coupling is comprised of 2 hubs, 2 hardware kits, and a UF Type center drop out section.
Unit of Measure

Specifications

Description 

 N/A RRU50-HDWR PKG

Type

 N/A Drop-Out

Material

 N/A Steel

# of Mounting Screws Required

 N/A 1

Weight

 N/A 0.05 lb

Dimensional Data

Height

 N/A 3.00 in

Depth

 N/A 1.00 in

Width

 N/A 5.00 in

Cubic inches

 N/A 15.00000 in³

Dimensional Data of Related Coupling

Size

 N/A RRU50

Set Screw Size

 N/A 1/4-20

Overall Length

 N/A 3.520 in89.41 mm

Pin Size

 N/A 0.125 in

Pin Location (Dimension SL)

 N/A 0.500 in

Min. Bore (Dimensions ID1/ID2)

 N/A 0.375 in10.00 mm

Max. Bore (Dimensions ID1/ID2)

 N/A 1.000 in25.00 mm

Dimension BC

 N/A 1.500 in38.10 mm

Dimension D

 N/A 1.880 in47.75 mm

Flange Diameter (Dimension FD)

 N/A 2.000 in50.80 mm

Dimension FL1

 N/A 0.250 in6.35 mm

Dimension HL

 N/A 1.000 in25.40 mm

Dimension S

 N/A 1.560 in39.62 mm

Performance Data of Related Coupling

Max. Torque

 N/A 82.00 in·lb9.30 N·m

Speed

 N/A 30000.00 rpm

Max. Angular Offset

 N/A 4.50 º

Max. Parallel Offset

 N/A 0.021 in0.53 mm

Wind-Up Angle at Max. Torque

 N/A 1.82 º

Max. Recommended End Play

 N/A 0.035 in0.89 mm

Rated HP at 100 rpm

 N/A 0.13 hp

Coupling Design

Coupling Design

 N/A Flexible Spring Type Coupling with Exclusive Triple Wound Spring Design
    The Uniflex Coupling is an all steel, single piece coupling that solves a variety of application concerns including: high misalignment, space limitations, high temperature, and exceptionally low backlash/windup. The unique flexing center of the Uniflex consists of three opposingly wound square wire springs for forward or reverse operation. Two steel hubs are then brazed to the steel spring pack to create a durable one-piece flexible coupling.

Notes

Notes 

 N/A
  • OAL Tolerance + .19 inch.
  • Total backlash is approximately 1/3 of windup at maximum torque – consult Lovejoy Engineering for more information.