The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back

Key Features

  • Longer bearing life achieved from higher capacity (vs. competitors)
  • Longer lubrication life achieved from lower operating temperatures due to reduced internal friction and running torque from cage guided rollers
  • Better contaminant purging from slots on cage face helps extend bearing life
  • Greater fatigue strength and increased wear resistance provide tougher protection against shock and acceleration loading from a brass cage
Unit of Measure

Key Dimensions

Bore (d)

 N/A 130 mm

O.D. (D)

 N/A 11.0233 in279.993 mm

Width (B)

 N/A 3.6614 in93 mm

Dynamic Radial Load Rating - 1M Revs (C1)

 N/A 281000 lbf1250000 N
e Factor 1 N/A 0.32

UPC Code

 N/A 087796223653

Other Dimensions

Bore_Taper

 N/A 1/12
Max Shaft Fillet Radius2 N/A 0.120 in3 mm

Shaft Backing Shoulder Diameter

 N/A 169.000 mm6.7000 in

Housing Backing Shoulder Diameter

 N/A 252 mm9.9000 in

Design Unit

 N/A Metric

Cage Type

 N/A EM

Cage Material

 N/A Brass

Superseded Part

 N/A 22326KYMW33W800C4

Ratings

Static Radial Load Rating (C0)

 N/A 318000 lbf1410000 N
Thermal Reference Speed - Oil 3 N/A 2000 rpm

Thermal Reference Speed - Grease 

 N/A 1800 rpm

Factors

Y0 Factor4 N/A 2.06
Y1 Factor 5 N/A 2.11
Y2 Factor 6 N/A 3.14
Geometry Factor (Cg) 7 N/A 0.0874
  • 1 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 2 Maximum housing fillet radius that bearing corners will clear.
  • 3 See thermal speed ratings in the engineering section.
  • 4 These factors apply for both inch and metric calculations. See engineering
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.