Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
C90 - Dynamic Radial Rating (90 million revolutions)4
N/A4820 lbf21400 N
C1 - Dynamic Radial Rating (1 million revolutions)5
N/A18600 lbf82600 N
C0 - Static Radial Rating
N/A14400 lbf64100 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6
N/A4960 lbf22100 N
Factors
K - Factor7
N/A0.97
e - ISO Factor8
N/A0.6
Y - ISO Factor9
N/A1
G1 - Heat Generation Factor (Roller-Raceway)
N/A13
G2 - Heat Generation Factor (Rib-Roller End)
N/A5.83
Cg - Geometry Factor10
N/A0.0686
1 These maximum fillet radii will be cleared by the bearing corners.
2 These maximum fillet radii will be cleared by the bearing corners.
3 Negative value indicates effective center inside cone backface.
4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
10 Geometry constant for Lubrication Life Adjustment Factor a3l.
© 2016 The Timken Company.