Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A 1163X

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 14500 lbf64400 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 3750 lbf16700 N

Dimensions

d - Cone Bore

 N/A 9/16 in14.288 mm

B - Cone Width

 N/A 0.8880 in22.555 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.06 in1.520 mm

da - Cone Frontface Backing Diameter

 N/A 0.77 in19.5 mm

db - Cone Backface Backing Diameter

 N/A 0.87 in22 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0 in0 mm

Aa - Cage-Cone Backface Clearance

 N/A 0 in0 mm
a - Effective Center Location4 N/A -0.43 in-10.9 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 2160 lbf9590 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 8320 lbf37000 N

C0 - Static Radial Rating

 N/A 8170 lbf36300 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 910 lbf4050 N

Factors

K - Factor8 N/A 2.37

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 6.7

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 4.8
Cg - Geometry Factor9 N/A 0.0413
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.