Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A 12580

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 17100 lbf76000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 4430 lbf19700 N

Dimensions

d - Cone Bore

 N/A 0.8125 in20.638 mm

B - Cone Width

 N/A 0.7813 in19.845 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.06 in1.520 mm

da - Cone Frontface Backing Diameter

 N/A 1.02 in26 mm

db - Cone Backface Backing Diameter

 N/A 1.12 in28.5 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.08 in2 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.01 in0.3 mm
a - Effective Center Location4 N/A -0.28 in-7.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 2540 lbf11300 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 9810 lbf43600 N

C0 - Static Radial Rating

 N/A 9720 lbf43200 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 1410 lbf6260 N

Factors

K - Factor8 N/A 1.81

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 8.6

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 6.21
Cg - Geometry Factor9 N/A 0.0495
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.