Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 565

Cone Part Number

 N/A 566X

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 71200 lbf317000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 18500 lbf82100 N

Dimensions

d - Cone Bore

 N/A 2 3/4 in69.850 mm

B - Cone Width

 N/A 1.4240 in36.170 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.270 in6.900 mm

da - Cone Frontface Backing Diameter

 N/A 3.07 in78 mm

db - Cone Backface Backing Diameter

 N/A 3.58 in91 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.09 in2.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.12 in3 mm
a - Effective Center Location4 N/A -0.32 in-8.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 10600 lbf47100 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 40900 lbf182000 N

C0 - Static Radial Rating

 N/A 58900 lbf262000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 6600 lbf29400 N

Factors

K - Factor8 N/A 1.61

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 101.3

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 24
Cg - Geometry Factor9 N/A 0.117
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.