Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 935

Cone Part Number

 N/A 943

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 224000 lbf996000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 58000 lbf258000 N

Dimensions

d - Cone Bore

 N/A 3.8750 in98.425 mm

B - Cone Width

 N/A 2.6250 in66.675 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.14 in3.600 mm

da - Cone Frontface Backing Diameter

 N/A 4.49 in114 mm

db - Cone Backface Backing Diameter

 N/A 4.72 in120 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.09 in2.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.23 in5.8 mm
a - Effective Center Location4 N/A -0.78 in-19.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 33300 lbf148000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 129000 lbf572000 N

C0 - Static Radial Rating

 N/A 177000 lbf786000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 18600 lbf82700 N

Factors

K - Factor8 N/A 1.79

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 338.6

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 39.8
Cg - Geometry Factor9 N/A 0.115
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.