Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A EE108065

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 566000 lbf2520000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 147000 lbf652000 N

Dimensions

d - Cone Bore

 N/A 6 1/2 in165.1 mm

B - Cone Width

 N/A 4.1250 in104.775 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.530 in13.460 mm

da - Cone Frontface Backing Diameter

 N/A 7.64 in194 mm

db - Cone Backface Backing Diameter

 N/A 8.46 in215 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.26 in6.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.63 in16 mm
a - Effective Center Location4 N/A -1.29 in-32.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 84200 lbf375000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 325000 lbf1450000 N

C0 - Static Radial Rating

 N/A 439000 lbf1950000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 48300 lbf215000 N

Factors

K - Factor8 N/A 1.74

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 942

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 71.4
Cg - Geometry Factor9 N/A 0.127
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.