Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 425000

Cone Part Number

 N/A EE425179A

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1390000 lbf6180000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 360000 lbf1600000 N

Dimensions

d - Cone Bore

 N/A 17.9840 in456.794 mm

B - Cone Width

 N/A 5.6250 in142.875 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.630 in16.000 mm

da - Cone Frontface Backing Diameter

 N/A 19.53 in496 mm

db - Cone Backface Backing Diameter

 N/A 20.67 in525 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.19 in4.8 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.77 in19.6 mm
a - Effective Center Location4 N/A 0.31 in7.9 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 207000 lbf920000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 798000 lbf3550000 N

C0 - Static Radial Rating

 N/A 1400000 lbf6210000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 156000 lbf695000 N

Factors

K - Factor8 N/A 1.32

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 5741.9

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 326.2
Cg - Geometry Factor9 N/A 0.253
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.