Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 455000

Cone Part Number

 N/A EE455055X

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 322000 lbf1430000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 83600 lbf372000 N

Dimensions

d - Cone Bore

 N/A 5.5118 in140 mm

B - Cone Width

 N/A 3.5000 in88.900 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.470 in11.900 mm

da - Cone Frontface Backing Diameter

 N/A 6.69 in170 mm

db - Cone Backface Backing Diameter

 N/A 7.13 in181 mm

Ab - Cage-Cone Frontface Clearance

 N/A -0.01 in-0.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.47 in11.9 mm
a - Effective Center Location4 N/A -1.11 in-28.2 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 48000 lbf214000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 185000 lbf824000 N

C0 - Static Radial Rating

 N/A 258000 lbf1150000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 25100 lbf112000 N

Factors

K - Factor8 N/A 1.91

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 569.6

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 57.3
Cg - Geometry Factor9 N/A 0.105
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.