Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A EE620100

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 704000 lbf3130000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 182000 lbf812000 N

Dimensions

d - Cone Bore

 N/A 10 in254 mm

B - Cone Width

 N/A 4.1250 in104.775 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.310 in7.870 mm

da - Cone Frontface Backing Diameter

 N/A 12.13 in308 mm

db - Cone Backface Backing Diameter

 N/A 12.48 in317 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.72 in18.3 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.95 in24.1 mm
a - Effective Center Location4 N/A 1.92 in48.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 105000 lbf466000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 404000 lbf1800000 N

C0 - Static Radial Rating

 N/A 603000 lbf2680000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 155000 lbf691000 N

Factors

K - Factor8 N/A 0.67

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 1730

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 165.3
Cg - Geometry Factor9 N/A 0.208
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.