Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 755000

Cone Part Number

 N/A EE755285

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 934000 lbf4150000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 242000 lbf1080000 N

Dimensions

d - Cone Bore

 N/A 28.5000 in723.900 mm

B - Cone Width

 N/A 3.1875 in80.963 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.22 in5.60 mm

da - Cone Frontface Backing Diameter

 N/A 29.53 in750 mm

db - Cone Backface Backing Diameter

 N/A 29.76 in756 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.36 in9.1 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.34 in8.6 mm
a - Effective Center Location4 N/A 2.17 in55.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 139000 lbf619000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 536000 lbf2390000 N

C0 - Static Radial Rating

 N/A 1170000 lbf5190000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 90600 lbf403000 N

Factors

K - Factor8 N/A 1.54

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 11122.5

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 1282.2
Cg - Geometry Factor9 N/A 0.295
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.