Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A EE776420

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1040000 lbf4640000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 271000 lbf1200000 N

Dimensions

d - Cone Bore

 N/A 42.0000 in1066.800 mm

B - Cone Width

 N/A 3.5000 in88.900 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.25 in6.35 mm

da - Cone Frontface Backing Diameter

 N/A 43.9 in1115 mm

db - Cone Backface Backing Diameter

 N/A 43.9 in1115 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.31 in7.87 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.5 in12.7 mm
a - Effective Center Location4 N/A 6.92 in175.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 155000 lbf691000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 599000 lbf2670000 N

C0 - Static Radial Rating

 N/A 1570000 lbf6990000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 152000 lbf676000 N

Factors

K - Factor8 N/A 1.02

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 23200

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 2946.7
Cg - Geometry Factor9 N/A 0.423
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.