Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A 790000

Cone Part Number

 N/A EE790116

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1210000 lbf5390000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 314000 lbf1400000 N

Dimensions

d - Cone Bore

 N/A 11 1/2 in292.100 mm

B - Cone Width

 N/A 5.3750 in136.525 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.780 in19.800 mm

da - Cone Frontface Backing Diameter

 N/A 12.95 in329 mm

db - Cone Backface Backing Diameter

 N/A 14.25 in362 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.34 in8.6 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.75 in19.1 mm
a - Effective Center Location4 N/A -0.96 in-24.4 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 180000 lbf802000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 695000 lbf3090000 N

C0 - Static Radial Rating

 N/A 923000 lbf4100000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 122000 lbf542000 N

Factors

K - Factor8 N/A 1.48

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 2663.9

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 170.3
Cg - Geometry Factor9 N/A 0.190
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.