Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A H969200

Cone Part Number

 N/A H969249

Design Units

 N/A Imperial

Cage Type

 N/A Pin-Type
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 1640000 lbf7280000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 425000 lbf1890000 N

Dimensions

d - Cone Bore

 N/A 16.0000 in406.400 mm

B - Cone Width

 N/A 6.3750 in161.925 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.500 in12.700 mm

da - Cone Frontface Backing Diameter

 N/A 18.24 in463.3 mm

db - Cone Backface Backing Diameter

 N/A 20.2 in513 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.94 in23.88 mm

Aa - Cage-Cone Backface Clearance

 N/A 1.03 in26.16 mm
a - Effective Center Location4 N/A 3.12 in79.2 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 244000 lbf1080000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 941000 lbf4180000 N

C0 - Static Radial Rating

 N/A 1540000 lbf6840000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 391000 lbf1740000 N

Factors

K - Factor8 N/A 0.62

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 4610

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 207
Cg - Geometry Factor9 N/A 0.294
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.