Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 N/A HH228300

Cone Part Number

 N/A HH228336

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 330000 lbf1470000 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 85500 lbf380000 N

Dimensions

d - Cone Bore

 N/A 4.7234 in119.974 mm

B - Cone Width

 N/A 3.2500 in82.550 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.16 in4.1 mm

da - Cone Frontface Backing Diameter

 N/A 5.59 in142 mm

db - Cone Backface Backing Diameter

 N/A 5.79 in147 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.02 in0.5 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.28 in7.1 mm
a - Effective Center Location4 N/A -0.92 in-23.4 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 49100 lbf218000 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 189000 lbf843000 N

C0 - Static Radial Rating

 N/A 279000 lbf1240000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 27000 lbf120000 N

Factors

K - Factor8 N/A 1.82

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 529.8

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 44.8
Cg - Geometry Factor9 N/A 0.133
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.