Aerospace / Military
Aerospace Series General Aviation Rod Ends Spherical Bearings Mil Spec Series Rod Ends Spherical Bearings Bushings Approved Part Numbers
Commercial / Industrial
Rod End Bearings Inch Rod Ends Metric Rod Ends Spherical Bearings Inch Spherical Bearings Metric Spherical Bearings
Technical Resources
Terms and Definitions Articles Technical Data FAQs Key Term Translation Custom Engineered Products
Online Catalog
Engineers power search our entire catalog of bearing and bushings, with access to every attribute and technical specification possible. View our online catalog...
Request Information
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Cone Part Number

 N/A HH228336

Bore (d)

 N/A 4.7234 in119.974 mm

Inner Ring Width (B)

 N/A 3.2500 in82.550 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 189000 lbf843000 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 49100 lbf218000 N
e Factor 3 N/A 0.67
K Factor 4 N/A 1.82
Y Factor 5 N/A 1.87

Other Dimensions

Effective Center Location6 N/A -0.92 in-23.4 mm
Max Shaft Fillet Radius7 N/A 0.160 in4.1 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 5.59 in142 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 5.79 in147 mm

Cage Location rel. to BF (Aa)

 N/A 0.28 in7.1 mm

Cage Location rel. to FF (Ab)

 N/A 0.02 in0.5 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)8 N/A 27000 lbf120000 N

Static Radial Load Rating (CO)

 N/A 279000 lbf1240000 N

Factors

G1 Factor

 N/A 529.8

G2 Factor

 N/A 44.8
Geometry Factor (Cg)9 N/A 0.133
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 Negative value indicates effective center inside cone backface.
  • 7 These maximum fillet radii will be cleared by the bearing corners.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.