Montage of Timken Bearing Products
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
Request Information Add to CAD Cart
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Cone Part Number

 N/A HM81649

Design Units

 N/A Imperial

Cage Type

 N/A Stamped Steel
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)1 N/A 15700 lbf69900 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)2 N/A 4070 lbf18100 N

Dimensions

d - Cone Bore

 N/A 0.6294 in15.987 mm

B - Cone Width

 N/A 0.8268 in21.001 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius3 N/A 0.040 in1.020 mm

da - Cone Frontface Backing Diameter

 N/A 0.9 in23 mm

db - Cone Backface Backing Diameter

 N/A 1.08 in27.5 mm

Ab - Cage-Cone Frontface Clearance

 N/A 0.08 in2 mm

Aa - Cage-Cone Backface Clearance

 N/A 0.03 in0.8 mm
a - Effective Center Location4 N/A -0.24 in-6.1 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)5 N/A 2340 lbf10400 N
C1 - Dynamic Radial Rating (1 million revolutions)6 N/A 9020 lbf40100 N

C0 - Static Radial Rating

 N/A 8840 lbf39300 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)7 N/A 2190 lbf9720 N

Factors

K - Factor8 N/A 1.07

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 6.1

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 4.57
Cg - Geometry Factor9 N/A 0.0526
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 3 These maximum fillet radii will be cleared by the bearing corners.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 6 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.