Aerospace / Military
Aerospace Series General Aviation Rod Ends Spherical Bearings Mil Spec Series Rod Ends Spherical Bearings Bushings Approved Part Numbers
Commercial / Industrial
Rod End Bearings Inch Rod Ends Metric Rod Ends Spherical Bearings Inch Spherical Bearings Metric Spherical Bearings
Technical Resources
Terms and Definitions Articles Technical Data FAQs Key Term Translation Custom Engineered Products
Online Catalog
Engineers power search our entire catalog of bearing and bushings, with access to every attribute and technical specification possible. View our online catalog...
Request Information
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Cone Part Number

 N/A LM67043

Bore (d)

 N/A 1 1/8 in28.575 mm

Inner Ring Width (B)

 N/A 0.6600 in16.764 mm
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 8210 lbf36500 N
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 2130 lbf9460 N
e Factor 3 N/A 0.41
K Factor 4 N/A 1.42
Y Factor 5 N/A 1.46

Other Dimensions

Weight

 N/A 0.6 lb0.3 Kg
Effective Center Location6 N/A -0.12 in-3 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 1.38 in35 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 1.63 in41.5 mm

Cage Location rel. to BF (Aa)

 N/A 0.02 in0.5 mm

Cage Location rel. to FF (Ab)

 N/A 0.05 in1.3 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)7 N/A 1500 lbf6680 N

Static Radial Load Rating (CO)

 N/A 10000 lbf44600 N

Factors

Geometry Factor (Cg)8 N/A 0.0612
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 Negative value indicates effective center inside cone backface.
  • 7 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 8 Geometry constant for Lubrication Life Adjustment Factor a3l.