Aerospace / Military
Aerospace Series General Aviation Rod Ends Spherical Bearings Mil Spec Series Rod Ends Spherical Bearings Bushings Approved Part Numbers
Commercial / Industrial
Rod End Bearings Inch Rod Ends Metric Rod Ends Spherical Bearings Inch Spherical Bearings Metric Spherical Bearings
Technical Resources
Terms and Definitions Articles Technical Data FAQs Key Term Translation Custom Engineered Products
Online Catalog
Engineers power search our entire catalog of bearing and bushings, with access to every attribute and technical specification possible. View our online catalog...
Request Information
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Bore (d)

 N/A 2.3750 in60.325 mm

Inner Ring Width (B)

 N/A 1.5625 in39.6875 mm
Dynamic Radial Load Rating - 90M Revs (C90) 1 N/A 11100 lbf49400 N
e Factor 2 N/A 0.35
K Factor 3 N/A 1.69

Other Dimensions

Effective Center Location4 N/A -0.37 in-9.4 mm
Max Shaft Fillet Radius5 N/A 0.140 in3.5 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 2.99 in76 mm

Cage Location rel. to BF (Aa)

 N/A 0.15625 in3.96875 mm

Cage Location rel. to FF (Ab)

 N/A -0.078125 in-1.984375 mm

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 65900 lbf29300 N
  • 1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.