Menu
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Click Here for Batch Download
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Specifications

Series

 5C

Cone Part Number

 4C

Cup Part Number

 6CE

Design Unit

 Inch

Cage Material

 Stamped Steel

Dimensions

d - Bore

 0.6875 in17.463 mm

D - Cup Outer Diameter

 1.9349 in49.146 mm

B - Cone Width

 0.4688 in11.908 mm

C - Cup Width

 0.7500 in19.050 mm

T - Bearing Width

 0.8703 in22.106 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 0.06 in1.520 mm
r - Cup Backface "To Clear" Radius2 0.1 in2.54 mm

da - Cone Frontface Backing Diameter

 0.87 in22 mm

db - Cone Backface Backing Diameter

 0.96 in24.5 mm

Da - Cup Frontface Backing Diameter

 1.61 in40.40 mm

Db - Cup Backface Backing Diameter

 1.46 in37.08 mm

Ab - Cage-Cone Frontface Clearance

 0.09 in2.3 mm

Aa - Cage-Cone Backface Clearance

 0.01 in0.3 mm
a - Effective Center Location3 -0.07 in-1.8 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)4 1180 lbf5250 N
C1 - Dynamic Radial Rating (1 million revolutions)5 4550 lbf20300 N

C0 - Static Radial Rating

 4640 lbf20600 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)6 969 lbf4310 N

Factors

K - Factor7 1.22
e - ISO Factor8 0.48
Y - ISO Factor9 1.25

G1 - Heat Generation Factor (Roller-Raceway)

 4.6

G2 - Heat Generation Factor (Rib-Roller End)

 2.6
Cg - Geometry Factor10 0.0456
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Negative value indicates effective center inside cone backface.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 Geometry constant for Lubrication Life Adjustment Factor a3l.