CAD (0) ▾
  • Cart is empty
  1. Request CAD files
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Request Information
Unit of Measure

Key Dimensions

Cone Part Number

 N/A LM102949CP

Bore (d)

 N/A 1.7812 in45.242 mm
Dynamic Radial Load Rating - 90M Revs (C90) 1 N/A 4250 lbf18900 N
Dynamic Radial Load Rating - 1M Revs (C1) 2 N/A 16400 lbf72900 N
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)3 N/A 28500 lbf127000 N
Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row) 4 N/A 7400 lbf32900 N
K Factor 5 N/A 1.91

Other Dimensions

Inner Ring Width (B)

 N/A 0.78 in19.812 mm
Max Shaft Fillet Radius6 N/A 0.14 in3.56 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 1.97 in50 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 2.2 in56 mm

Cage Location Relative to Frontface (Ab) 

 N/A 0.07 in1.8 mm

Cage Location Relative to Backface (Aa)

 N/A 0.01 in0.3 mm
Effective Center Location7 N/A -0.18 in-4.6 mm

Weight

 N/A 0.7 lb0.30 Kg

Ratings

Static Radial Load Rating (C0)

 N/A 18400 lbf81800 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)8 N/A 2220 lbf9870 N

Factors

G1 Factor

 N/A 31.1

G2 Factor

 N/A 18.8
Geometry Factor (Cg)9 N/A 0.0744
  • 1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 3 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 These maximum fillet radii will be cleared by the bearing corners.
  • 7 Negative value indicates effective center inside cone backface.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.