The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
Unit of Measure

Other Dimensions

Weight

 N/A 3.52 Kg7.78 lb

Width (T)

 N/A 2.7559 in70 mm

B - Width

 N/A 2.6772 in68.000 mm
Max Shaft Fillet Radius1 N/A 0.010 in0.3 mm
Max Housing Fillet Radius2 N/A 0.1 in2.54 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 3.7 in94 mm

Housing Backing Shoulder Diameter - Frontface (Da)

 N/A 4.96 in125 mm

Key Dimensions

Cone Part Number

 N/A JM515649

Cup Part Number

 N/A JM515610

Outer Spacer Part Number

 N/A JY13013-Q

Design Unit

 N/A Metric

Bore (d)

 N/A 3.1496 in80 mm

O.D. (D)

 N/A 5.1181 in130 mm
Dynamic Radial Load Rating - 90M Revs (C90) 3 N/A 13700 lbf61000 N
Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row)4 N/A 23900 lbf106000 N
K Factor 5 N/A 1.5
e Factor 6 N/A 0.39

Ratings

C1 - Dynamic Radial Rating (1 million revolutions)7 N/A 92100 lbf410000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)8 N/A 9120 lbf40600 N

Factors

Y1 Factor 9 N/A 1.74
Y2 Factor 10 N/A 2.59
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 6 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 7 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 10 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.