The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Other Dimensions

Weight

 N/A 2.2 Kg4.9 lb

Inner Ring Width (B)

 N/A 39 mm1.5354 in
Max Shaft Fillet Radius1 N/A 2.03 mm0.08 in

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 102 mm4.02 in

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 106 mm4.17 in

Cage Location Relative to Frontface (Ab) 

 N/A 3 mm0.12 in

Cage Location Relative to Backface (Aa)

 N/A 1.3 mm0.05 in
Effective Center Location2 N/A -10.2 mm-0.4 in

Key Dimensions

Series

 N/A 33019

Cone Part Number

 N/A X33019

Bore (d)

 N/A 95 mm3.7402 in
Dynamic Radial Load Rating - 90M Revs (C90) 3 N/A 63800 N14300 lbf
Dynamic Radial Load Rating - 1M Revs (C1) 4 N/A 246000 N55300 lbf
C1 - Dynamic Radial Rating (Two-Row, 1 million revolutions)5 N/A 429000 N96400 lbf
Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row) 6 N/A 111000 N25000 lbf
K Factor 7 N/A 2.1

Ratings

Static Radial Load Rating (C0)

 N/A 378000 N85100 lbf
Ca90 - Dynamic Thrust Rating (90 million revolutions)8 N/A 30400 N6830 lbf

Factors

G1 Factor

 N/A 192.5

G2 Factor

 N/A 48.4
Geometry Factor (Cg)9 N/A 0.0907
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 Negative value indicates effective center inside cone backface.
  • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 4 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 5 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 9 Geometry constant for Lubrication Life Adjustment Factor a3l.