The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Series

 N/A 455

Cone Part Number

 N/A NA456SW

Bore (d)

 N/A 2 in50.8 mm
Dynamic Radial Load Rating - 90M Revs (C90) 1 N/A 7900 lbf35200 N
Dynamic Radial Load Rating - 1M Revs (C1) 2 N/A 30500 lbf136000 N
K Factor 3 N/A 1.74

Other Dimensions

Inner Ring Width (B)

 N/A 1.4688 in37.308 mm
Max Shaft Fillet Radius4 N/A 0.14 in3.556 mm

Shaft Backing Shoulder Diameter - Frontface (da)

 N/A 0 in0 mm

Shaft Backing Shoulder Diameter - Backface (db)

 N/A 2.56 in65 mm

Cage Location Relative to Frontface (Ab) 

 N/A -0.05 in-1.3 mm

Cage Location Relative to Backface (Aa)

 N/A 0.26 in6.6 mm
Effective Center Location5 N/A -0.46 in-11.7 mm

Weight

 N/A 6.65 lb

Ratings

Ca90 - Dynamic Thrust Rating (90 million revolutions)6 N/A 4540 lbf20200 N

Factors

G1 Factor

 N/A 58.6

G2 Factor

 N/A 17.1
  • 1 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 2 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These maximum fillet radii will be cleared by the bearing corners.
  • 5 Negative value indicates effective center inside cone backface.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.