UFH Type without Keyway, Regular & Short Version - Inch (Imperial) Bores On The Timken Company


All Product Types > INDUSTRIAL MOTION PRODUCTS > Couplings & Power Transmission Parts Catalog > Specialty Products - Uniflex, Saga, Rigid Sleeve, Shaft Collars > Uniflex Couplings > UFH Type without Keyway, Regular & Short Version - Inch (Imperial) Bores > View Items


	UFH Type without Keyway, Regular & Short Version - Inch (Imperial) Bores
	Check up to five results to perform an action.

	UFH Type - Flange-to-Shaft A flange-to-shaft configuration, this couples flange mounted equipment to a shaft with all the benefits of Uniflex versatility. The stock flange plate is the same as used on the UF Type. The one-piece UFH Type coupling is similar to the U Type, except that one hub is replaced by a flange plate. Stock flange sizes are shown in the Dimensional Data table below but other sizes can be made to order. As with the other Uniflex styles, this coupling compensates for high degrees of angular and parallel misalignment with very little backlash or windup and is reliable in harsh or severe environments. Regular and short versions are available for each size to accommodate different overall length requirements. For increased versatility, the hub can be modified with a tapered, spline, hex or square bore. The standard hub is furnished with either a pre-drilled pin hole or with a keyway and set screw. Specify when ordering. Note: The UFH Type coupling does not come with assembly hardware. Assembly hardware must be purchased separately.
	larger image	larger image