2TS-DM assemblies are comprised of two single-row bearings with abutting back facing inner rings and an outer ring spacer with lubricating holes is typical. These are generally used at fixed positions on rotating shaft applications.

Design Attributes:
  • Two single row bearings, with or without a spacer
  • When spacers are used, bearing is furnished as a preset, matched assembly
  • Spacers available with or without lubricant grooves and holes
    • Unit of Measure

    Key Dimensions

    Cone Part Number

    		 N/A 29676

    Cup Part Number

    		 N/A 29620

    Outer Spacer Part Number

    		 N/A Y1S-29620

    Bore (d)

    		 N/A 2 3/4 in69.850 mm

    O.D. (D)

    		 N/A 4.4375 in112.713 mm

    Width (T)

    		 N/A 2.013 in51.13 mm
    Dynamic Radial Load Rating - 1M Revs (C1)1 N/A 43300 lbf192000 N
    Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 6440 lbf28600 N
    Dynamic Radial Load Rating 2-Row - 90M Revs (C90-2row)3 N/A 11200 lbf49900 N
    e Factor 4 N/A 0.49
    K Factor 5 N/A 1.2

    Other Dimensions

    Weight

    		 N/A 24.26 Kg53.51 lb

    Width (B)

    		 N/A 2 in50.8 mm
    Max Shaft Fillet Radius6 N/A 0.080 in2.000 mm
    Max Housing Fillet Radius7 N/A 0.130 in3.30 mm

    Shaft Backing Shoulder Dia. - Backface (db)

    		 N/A 3.15 in80 mm

    Housing Backing Shoulder Dia. - Frontface (Da)

    		 N/A 4.33 in109.00 mm

    Ratings

    Dynamic Axial Rating - 90M Revs (Ca90)8 N/A 5370 lbf23900 N

    Factors

    Y1 Factor 9 N/A 1.38
    Y2 Factor 10 N/A 2.06
    • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
    • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
    • 3 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
    • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
    • 5 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
    • 6 These maximum fillet radii will be cleared by the bearing corners.
    • 7 These maximum fillet radii will be cleared by the bearing corners.
    • 8 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
    • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
    • 10 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.