This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

RELATED PRODUCTS

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A JM734449

Bore (d)

 N/A 170 mm6.6929 in
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 401000 N90200 lbf
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 104000 N23400 lbf
K Factor 3 N/A 1.34

Other Dimensions

Weight

 N/A 6.8 Kg14.9 lb

Inner Ring Width (B)

 N/A 44.500 mm1.7520 in
Effective Center Location4 N/A 5.1 mm0.2 in
Max Shaft Fillet Radius5 N/A 3.050 mm0.12 in

Shaft Backing Shoulder Dia. - Frontface (da)

 N/A 180 mm7.09 in

Shaft Backing Shoulder Dia. - Backface (db)

 N/A 185 mm7.28 in

Cage Location rel. to BF (Aa)

 N/A 2 mm0.08 in

Cage Location rel. to FF (Ab)

 N/A 4.8 mm0.19 in

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 77900 N17500 lbf

Static Radial Load Rating (C0)

 N/A 759000 N171000 lbf

Factors

G1 Factor

 N/A 548.5

G2 Factor

 N/A 117.5
Geometry Factor (Cg)7 N/A 0.116
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.