This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A X32007X

Bore (d)

 N/A 35 mm1.378 in
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 56500 N12700 lbf
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 14600 N3290 lbf
K Factor 3 N/A 1.29

Other Dimensions

Weight

 N/A 0.20 Kg0.5 lb

Inner Ring Width (B)

 N/A 18 mm0.7087 in
Effective Center Location4 N/A -2.5 mm-0.1 in
Max Shaft Fillet Radius5 N/A 1.020 mm0.04 in

Shaft Backing Shoulder Dia. - Frontface (da)

 N/A 41.5 mm1.63 in

Shaft Backing Shoulder Dia. - Backface (db)

 N/A 43 mm1.69 in

Cage Location rel. to BF (Aa)

 N/A 0.3 mm0.01 in

Cage Location rel. to FF (Ab)

 N/A 1.8 mm0.07 in

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 11400 N2560 lbf

Static Radial Load Rating (C0)

 N/A 57600 N12900 lbf

Factors

G1 Factor

 N/A 16.7

G2 Factor

 N/A 15.7
Geometry Factor (Cg)7 N/A 0.0691
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.