This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.
Unit of Measure

Key Dimensions

Cone Part Number

 N/A X33021

Bore (d)

 N/A 105.000 mm4.1339 in
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 291000 N65400 lbf
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 75400 N17000 lbf
K Factor 3 N/A 2.07

Other Dimensions

Weight

 N/A 3 Kg6.5 lb

Inner Ring Width (B)

 N/A 43 mm1.6929 in
Effective Center Location4 N/A -12.2 mm-0.48 in
Max Shaft Fillet Radius5 N/A 2.540 mm0.1 in

Shaft Backing Shoulder Dia. - Frontface (da)

 N/A 113 mm4.45 in

Shaft Backing Shoulder Dia. - Backface (db)

 N/A 118 mm4.65 in

Cage Location rel. to BF (Aa)

 N/A 2.5 mm0.1 in

Cage Location rel. to FF (Ab)

 N/A 3.8 mm0.15 in

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 36500 N8200 lbf

Static Radial Load Rating (C0)

 N/A 449000 N101000 lbf

Factors

G1 Factor

 N/A 236.3

G2 Factor

 N/A 54.8
Geometry Factor (Cg)7 N/A 0.0975
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.