This is the most basic and most widely used type of tapered roller bearing. It consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft.

RELATED PRODUCTS

Unit of Measure

Key Dimensions

Cone Part Number

 N/A X33109

Bore (d)

 N/A 45 mm1.7717 in
Dynamic Radial Load Rating - 1M Revs (C1) 1 N/A 113000 N25300 lbf
Dynamic Radial Load Rating - 90M Revs (C90) 2 N/A 29200 N6570 lbf
K Factor 3 N/A 1.52

Other Dimensions

Weight

 N/A 0.5 Kg1.2 lb

Inner Ring Width (B)

 N/A 26.000 mm1.0236 in
Effective Center Location4 N/A -6.6 mm-0.26 in
Max Shaft Fillet Radius5 N/A 1.520 mm0.06 in

Shaft Backing Shoulder Dia. - Frontface (da)

 N/A 52 mm2.05 in

Shaft Backing Shoulder Dia. - Backface (db)

 N/A 55 mm2.17 in

Cage Location rel. to BF (Aa)

 N/A 1.5 mm0.06 in

Cage Location rel. to FF (Ab)

 N/A 2.3 mm0.09 in

Ratings

Dynamic Axial Rating - 90M Revs (Ca90)6 N/A 19200 N4310 lbf

Static Radial Load Rating (C0)

 N/A 119000 N26800 lbf

Factors

G1 Factor

 N/A 35.7

G2 Factor

 N/A 16.5
Geometry Factor (Cg)7 N/A 0.0843
  • 1 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 2 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 Negative value indicates effective center inside cone backface.
  • 5 These maximum fillet radii will be cleared by the bearing corners.
  • 6 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 7 Geometry constant for Lubrication Life Adjustment Factor a3l.